Page tree
Skip to end of metadata
Go to start of metadata

You can clear the databases in your SmartServer, and you can reset the SmartServer to the same configuration as it ships from the factory.  This topic describes how you can perform these operations using the System Configuration page.

The System Configuration page provides the ability to:

  • Reset Databases – this process clears the SmartServer databases without changing the SmartServer IP addresses. Use Reset Databases to rebuild the SmartServer database or if a problem is observed.

  • Restore Factory Settings – this process performs the following operations and then restarts the SmartServer:
    • SmartServer factory settings are restored including IP and port settings
    • Services are stopped
    • Databases are cleared
    • Custom web pages and applications are deleted

Use Restore Factory Settings if the reset databases operation does not succeed, you encounter problems with the SmartServer IP settings, or you want to completely clean the SmartServer.

This section consists of the following:

Note: For SmartServer 3.1 and prior

If you are using SmartServer 3.1 or a prior release, and you have more than one LON network interface (U60 or U70) attached to a SmartServer, disconnect all but one of the LON network interfaces before resetting to factory defaults. Plug the LON network interfaces back in after the reset is complete.  This is not required if you are only resetting databases.

Resetting the Databases to Defaults Using the Configuration Page

To restore factory settings for databases using the SmartServer Configuration page, follow the steps below.

  1. Open the SmartServer Configuration page as described in the Configure Your SmartServer section, Accessing the SmartServer Configuration Page.

    The Network Configuration page appears.



  2. Click System at the top of the page.

    The System Configuration page appears.



  3. Click Reset To Defaults.


  4. The RESTORE DEFAULT SETTINGS display appears.



  5. To reset databases, enter the current password in the appropriate fields and click Update in the Reset Databases area.



    Allow about 10 minutes for the SmartServer to initialize.

Resetting the System to Defaults Using the Configuration Page

To restore factory settings for the system using the SmartServer Configuration page, follow the steps below.

  1. Open the SmartServer Configuration page as described in the Configure Your SmartServer section, Accessing the SmartServer Configuration Page.

    The Network Configuration page appears.



  2. Click System at the top of the page.

    The System Configuration page appears.



  3. Click Reset To Defaults.


  4. The RESTORE DEFAULT SETTINGS display appears.



  5. To restore factory settings for the system, click Update in the Restore Factory Settings area.



    Allow about 10 minutes for the SmartServer to initialize.

  • No labels